This weekend I continued cutting all the gauge holes into the dash and also cut the holes for the turn signal lamps, the brights lamp and the parking brake lamp. I’m using LEDs I got from the local electronics place for these four indicators. After I got all the holes cut I used glazing putty and primer to clean up what I had.
-
- speedo and tach test fit
-
- 2 of the smaller gauge holes are now done
-
- test fitting the smaller gauges
-
- all of the gauges test fit
-
- turn signals, brights lamp and parking brake lamp test fit
-
- starting the “bodywork” on the dash
-
- more primer and glazing putty
-
- done for now. dash primered.